Monster Power PRO7000 - Manuel (Page 30)

24
TROUBLESHOOTING
Symptom Possible Cause Remedy
The Unswitched LED
on front panel is Off. The PowerSource is not plugged in. • Plug the PowerSource into a properly
grounded 120 volts (nominal) outlet
and make sure it is on.
The PowerSource is plugged in,
but the outlet is not receiving power.
The Switched LED is Off. You are using the Switched Outlet
Remote Turn-On feature and haven’t
plugged the plug into the component
you wish to use to activate the
Remote Turn-On. • Plug the plug into the component
you wish to use to activate
the Remote Turn-On.
The component remote control
you are using to power the Remote
turn-on has a dead battery. • Replace the battery powering
the component remote control.
• Plug the component into a properly
grounded 120 volt (nominal) outlet.
The component you wish to use
to activate the Remote Turn-On
isn’t plugged into a properly grounded
120 volt (nominal) outlet. • Plug the PowerSource into a properly
grounded 120 volts (nominal) outlet.