Monster Power PRO7000 - Manuel (Page 28)

22
TROUBLESHOOTING
Symptom Possible Cause Remedy
The PowerSource is
not receiving power. The PowerSource
is not turned On. • Turn the PowerSource switch on.
• Make sure the PowerSource’s AC power plug
is plugged into a properly grounded
120 volts (nominal) wall outlet.
• In some households, a wall switch may need
to be thrown to make the wall plug active.
Try turning on the light switches located
near the wall unit.
Too many devices are
connected, causing an
overload, tripping the
Thermal Circuit Breaker. • Press the PowerSource Thermal Circuit
Breaker button in to reset. Please allow
10 minutes before attempting to reset.
If you reset too soon, the breaker will
prematurely sense power overload and
not allow unit to operate.
• If the Circuit Breaker continues to trip,
try moving one or more components
to another PowerSource. You may be drawing
too much current through one PowerSource.