Maytag Bravos W10092822A - Manuel (Page 12)

12
Separate sheets, pillowcases, and light blankets or throws and
■ ■
use the Sheets cycle for these items. For best performance, drop
items in loose heaps evenly around the basket wall and do not
load items directly on the impeller for this cycle.
When washing waterproof/water-resistant items such as plastic
■ ■
lined mattress pads, shower curtains, tarps, jackets, or sleeping
bags, select the lowest spin speed setting available for the cycle
and washer model being used.
Loading/Unloading
For best performance, load garments in loose heaps evenly
■ ■
around the basket wall. Do not load above the stainless steel
portion of the basket.
Remove clothes from washer after the cycle is completed.
■ ■
Metal objects such as zippers, snaps, and buckles may rust
if left in the washer basket for a long time.
Brush away lint and dirt. Treat spots and stains; stained or wet
■ ■
garments should be washed promptly for best results.
Mend tears, loose hems, and seams.
■ ■
Sorting
Separate heavily soiled items from lightly soiled ones, even
■ ■
if they would normally be washed together. Separate lint-
givers (towels, chenille) from lint-takers (corduroy, synthetics,
permanent press). When possible, turn lint-givers inside out.
Separate dark colors from light colors, colorfast items from
■ ■
noncolorfast items.
Sort by fabric and construction (sturdy cottons, knits, delicate
■ ■
items).
Separate bulky, nonabsorbent items such as comforters, pillows,
■ ■
and poly-filled jackets. Use the Bulky cycle for these items.
WASHER CARE
Cleaning Your Washer
Washer Maintenance procedure
This washer has a special cycle that uses higher water volumes,
in combination with AFFRESH ® washer cleaner or liquid chlorine
bleach to thoroughly clean the inside of the washer.
NOTES:
Read these instructions completely before beginning the
■ ■
cleaning process.
After every 45 cycles, the Clean Washer Reminder status light
■ ■
glows. Light can be deactivated by running the Clean Washer with
AFFRESH™ cycle or you can press the Reminder Reset button and
start the Clean Washer Reminder cycle count over again.
It is recommended that you allow the cleanout cycle to
■ ■
complete without interruptions. If necessary, the cleanout cycle
may be cancelled by pressing the Power/Cancel button once.
IMpORTANT: If the cleanout cycle is cancelled, run a Rinse
& Spin cycle to ensure that all remaining washer cleaner or
bleach is rinsed from the washer.
Begin procedure
1. Open the washer lid and remove any clothing or items from the
washer.
2. Using the AFFRESH ® washer cleaner (Recommended):
Add one AFFRESH ® washer cleaner tablet to the washer basket.
If using liquid chlorine bleach:
Add 1 cup (250 mL) liquid chlorine bleach to the bleach
dispenser.
NOTE: Do not add any detergent or load to this cleaning cycle.
Use of more than 1 cup (250 mL) of bleach will cause product
damage over time.
3. Close the lid.
4. Turn Cycle Control knob to Clean Washer with AFFRESH
™
cycle.
The Estimated Time Remaining display will show
■
approximately 1:02.
5. Press START/PAUSE.
The cycle will begin and water will dispense in the washer
■
for a moment and pause, then the lid will lock and the
cycle will continue.
Once the cleaning cycle has begun, allow the cycle to
■
complete. An estimated cycle time will appear on the
display.
Always do the following to maintain washer freshness
Use only HE detergent when washing a clothes load.
■ ■
Repeat the cleaning procedure monthly, using one AFFRESH
■ ■ ®
clean washer tablet or 1 cup (250 mL) of liquid chlorine
bleach.
If the procedure does not sufficiently improve washer freshness,
■ ■
evaluate your installation and usage conditions for other
causes.
Cleaning the exterior
Use a soft damp cloth or sponge to wipe up any spills.
Occasionally wipe the outside of your washer to keep it looking
new. Use mild soap and water. Do not use abrasive products.
Water Inlet Hoses
Replace inlet hoses after 5 years of use to reduce the risk of hose
failure. Periodically inspect and replace inlet hoses if bulges, kinks,
cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement on
the label with a permanent marker.