Maytag Bravos W10092822A - Manuel (Page 11)

11
Cycle Clean Boost with Heater
(Adds time to the wash cycle)
power Wash Option
Colors/Towels Option
Rapid Wash Option
Hand Wash Option
Clean Washer with AffRESH ™ Not available
Soak Not available
Rinse & Spin Not available
Drain & Spin Not available
fabric Softener
Fabric Softener option must be selected if liquid fabric softener is
added to the fabric softener dispenser. Fabric softener will also be
dispensed in the last rinse of the Extra Rinse cycle, if selected. This
option flushes the dispenser at the correct time in a deep water
rinse for optimal distribution.
Extra Rinse
An Extra Rinse can be used to aid in the removal of detergent or
bleach residue, or particulates such as sand and lint, from the
load. This option provides an additional rinse with the same water
temperature as the first rinse. This is the default rinse setting for the
Whites cycle.
End Signal - Off - Low - Hi Cycle Volume
The End Signal produces an audible sound when the wash cycle is
finished. This signal is helpful when you are removing items from
the washer as soon as it stops. Select Off, Low, or Hi for volume
sound.
Changing Cycles, Modifiers,
and Options
You can change Cycles, Modifiers, and Options anytime before
Start/Pause is pressed. Not all Modifiers and Options are available
for all cycles.
A short tone sounds when a change is selected. If you press and
■ ■
hold the End Signal option for more than five seconds, all valid
beeps will be eliminated. To turn the signals back on, press and
hold the End Signal button for five seconds.
Three short tones sound if an unavailable combination is
■ ■
selected. The last selection will not be accepted.
To return all options and modifiers to Factory Default, press
■ ■
POWER/CANCEL, select Drain & Spin cycle, and then press
Extra Rinse, Fabric Softener, Extra Rinse, Fabric Softener within
5 seconds. When done correctly, the 7-segment displays show
“Fd” for 3 seconds and then unit returns to Standby Mode.
Changing Cycles after pressing Start
1. Press POWER/CANCEL once to cancel the cycle. The washer
will drain.
2. Select the desired wash cycle.
3. Select the desired Modifiers and Options.
4. Press START/PAUSE.
The washer restarts at the beginning of the new cycle.
NOTE: If you do not press Start/Pause within 5 minutes of pausing
the washer, the washer automatically shuts off.
Changing Modifiers and Options after pressing Start/pause
You can change a Modifier or Option anytime before the selected
Modifier or Option begins by choosing the desired Modifiers and/
or Options.
NOTE: An error tone will sound if your selection is unavailable.
To manually drain the washer and spin the load
1. Press POWER/CANCEL once to cancel the wash cycle and
drain the washer.
2. Turn knob to select DRAIN & SPIN.
3. Press START/PAUSE.
When the spin is complete, the lid unlocks. Items can be removed
from the washer.
Normal Sounds
Your new washer may make sounds your old one didn’t. Because
the sounds might be unfamiliar, you may be concerned about
them. These sounds are normal.
During washing
You will hear spin/spray noise throughout the cycle.
During drain
If water is drained quickly from your washer (depending on your
installation), you may hear air being pulled through the pump
during the end of draining.
During wash and spin
This washer does not have a transmission. The motor provides
direct drive for agitation and spin. You will hear sounds that are
different from those of a conventional washer.
LAUNDRY TIpS
preparing clothes for washing
Follow these recommendations to help you prolong the life of your
garments.
Use only High Efficiency detergents. The package for this
■ ■
type of detergent will be marked “HE” or “High Efficiency.”
This wash system, along with less water, will create too
much sudsing with a regular non-HE detergent. Using regular
detergent will likely result in washer errors, longer cycle
times, and reduced rinsing performance. It may also result
in component failures and noticeable mold or mildew. HE
detergents are made to produce the right amount of suds for
the best performance. Follow the manufacturer’s instructions
to determine the amount of detergent to use. Remember,
concentrated detergents such as 2x or higher will use less
detergent based on load size.
Use only HE detergent.
Close zippers, snaps, and hooks to avoid snagging other items.
■ ■
Tie strings and sashes to avoid tangles.
Remove pins, buckles, and other hard objects to avoid
■ ■
scratching the washer interior. Remove non-washable trim and
ornaments.
Empty pockets and turn them inside out; turn down cuffs. Turn
■ ■
wool and synthetic knits inside out to avoid pilling.