Marvel Group 36" PRO+ - Manuel (Page 8)

7
Adjust the Door
Depending on your model, your refrigerator may have two
(Style 1 ) or four ( Style 2 ) adjustable rollers located at the base of
the refrigerator. If your refrigerator seems unsteady or you want
the door to close easier, adjust the refrigerator's tilt using the
instructions below.
1.
toward you.
2. Using a screwdriver or " hex driver, turn the roller
adjustment screw(s) on each side to raise or lower that side of
the refrigerator.
NOTE: Having someone push against the top of the
rollers. This makes it easier to turn the screws.
To raise, turn the roller adjustment screw to the right.
To lower, turn the roller adjustment screw to the left.
NOTE: It may take several turns of the roller adjustment
screw to adjust the tilt of the refrigerator.
Style 1 - Front leveling
Style 2 - Front and rear leveling
3. Open the door again to make sure that it closes as easily as
you like. If not, tilt the refrigerator slightly more to the rear by
turning both front adjustment screws to the right. It may take
several more turns, and you should turn both adjustment
screws the same amount.
4. Lower the stabilizing foot by turning it clockwise until it is
5. Turn the front adjustment screws counterclockwise to allow
the full weight of the refrigerator to rest on the stabilizing feet.
6. Replace the base grille.
Water System Preparation
Please read before using the water system.
Immediately after installation, follow the steps below to make
1.
2.
bracket is located on the left side wall of the refrigerator
compartment.
Remove blue bypass cap and retain for later use.
3. Flush the water system by dispensing and discarding 2 to
3 gal. (8 to 12 L) of water. Flushing the system will take
approximately 6 to 7 minutes and will help clear air from the
NOTE: As air is cleared from the system, water may spurt out
of the dispenser.
4.
leaks, see the “Troubleshooting ” section.
5. Turn on the ice maker by opening the freezer door and
Please refer to the
“Ice Maker ” section for further instructions on the operation
of your ice maker.
A. Roller adjustment screw
B. Stabilizing foot
A. Front adjustment screw
B. Rear adjustment screw
C. Stabilizing foot
A
B
A B A B
C C
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
may be used on disinfected waters that may contain