Maytag W10092797B - Manuel (Page 7)

7
■ Is there above average iron (rust) in water? You may need to
install an iron filter.
■ Did you properly sort the load? Sort dark clothes from whites
and lights.
■ Did you unload the washer promptly? To avoid the transfer of
dye, unload the washer as soon as it stops.
Load is wrinkled
■ Did you unload the washer promptly? Unload the washer as
soon as it stops.
■ Did you use the right cycle for the load being washed?
Use the cycle for Casual or Permanent Press clothes or another
cycle with low spin speeds (if available) to reduce wrinkling.
■ Did you overload the washer? The wash load must be balanced
and not overloaded. Loads should move freely during washing.
To reduce wrinkling of permanent press clothes and some
synthetic knits, use a large load size to provide more space.
■ Are the hot and cold water hoses reversed? Check that the hot
and cold water hoses are connected to the right faucets. See
“Connect the Inlet Hoses.”
Load is tangled or twisted
■ Did you overload the washer? The wash load must be balanced
and not overloaded. Loads should move freely during washing.
■ Did you wrap items around the agitator? Drop items loosely
into the washer. Do not wrap items around the agitator.
Gray whites, dingy colors
■ Did you properly sort the load? Transfer of dye can occur when
mixing whites and colors in a load. Sort dark clothes from whites
and lights.
■ Was the wash temperature too low? Use hot or warm washes if
safe for the load. Make sure your hot water system is adequate to
provide a hot water wash.
■ Did you use enough detergent, or do you have hard water? Use
more detergent for washing heavy soils in cold or hard water.
■ Are the hot and cold water hoses reversed? Check that the hot
and cold water hoses are connected to the right faucets. See
“Connect the Inlet Hoses.”
Garments damaged
■ Check the following:
Were sharp items removed from pockets before washing? Empty
pockets, zip zippers, snap or hook fasteners before washing.
Were strings and sashes tied to avoid tangling?
Were items damaged before washing? Mend rips and broken
threads in seams before washing.
■ Did you overload the washer? The wash load must be balanced
and not overloaded. Loads should move freely during washing.
■ Did you add chlorine bleach properly? Do not pour chlorine
bleach directly onto load. Wipe up bleach spills. Undiluted
bleach will damage fabrics. Do not place load items on top of
the bleach dispenser when loading and unloading the washer
(on some models).
■ Did you follow the manufacturer’s care label instructions?