Stop, Putting into operation – Makita DCS460 Manuel d'utilisation
Page 19
19
5
7
1
2
3
C
D
STOP
B
A
a
6
5
4
Put on the guide bar (
7
). Make sure that the pin (
5
) of the chain
tensioner engages in the hole in the guide bar.
Remove the plastic transport cover (
a
) and dispose of properly.
Turn chain tensioning screw (
4
) to the left (counter-clockwise)
until the pin (
5
) of the chain tensioner is underneath the
threaded pin (
6
).
Mounting the guide bar and saw chain
Use the universal wrench delivered with the chain saw for the
following work.
Put the chain saw on a stable surface and carry out the
following steps for mounting the guide bar and saw chain:
Release the chain brake by pulling the hand guard (
1
) in
direction of arrow.
Unscrew retaining nuts (
2
).
Pull off the sprocket guard (
3
).
PUTTING INTO OPERATION
CAUTION:
Before doing any work on the guide bar or chain, always
switch off the engine and pull the plug cap off the spark
plug
(see "Replacing the spark plug")
. Always wear protec-
tive gloves!
CAUTION:
Start the chain saw only after having assembled it com-
pletely and inspected.