GE Monogram MONOGRAM ZBD6800 - Manuel (Page 13)

13
Installation Instructions
CONNECT DRAIN LINE
FOLLOW ALL LOCAL CODES AND ORDINANCES.
The drain hose molded end will fit 5/8" or 1" diameter
connections on the air gap, waste tee or disposer. Cut
on the marked line as required for your installation.
• If a longer drain hose is required, add up to 42" of
length for a total of 10 ft. to the factory installed hose.
Use 5/8" or 7/8" inside diameter hose and a coupler to
connect the two hose ends. Secure the connection
with hose clamps.
• Secure the drain hose to the air gap, waste tee or
disposer with clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED
10 FEET FOR PROPER DRAIN OPERATION.
DRAIN LINE INSTALLATION
• Connect drain line to air gap, waste tee or disposer
using either previously determined method.
Method 1—Air gap with waste tee or disposer
Method 2—“High drain loop” with waste tee or
disposer
IMPORTANT
— When
connecting drain line to disposer,
check to be sure that drain plug has
been removed. DISHWASHER WILL
NOT DRAIN IF PLUG IS LEFT IN PLACE.
TIP: Avoid unnecessary service call charges. Always
be sure disposer drain plug has been removed before
attaching dishwasher drain hose to the disposer.
STEP 14
CONNECT WATER SUPPLY
Connect water supply line to 90° elbow.
• Slide compression nut, then ferrule over end of
water line.
• Insert water line into 90° elbow.
• Slide ferrule against elbow and secure with
compression nut.
IMPORTANT
— Check to be sure that door
spring does not rub or contact the fill hose or water supply
line. Test by opening and closing the door. Re-route the
lines if a rubbing noise or interference occurs.
STEP 13
90 ° Elbow
Ferrule
90
° Elbow
Compression Nut
Door Spring
Hot Water
Supply Line
Figure CC
Cutting Line
1" 5/8"
IMPORTANT: Do not cut corrugated
portion of hose
Figure DD
Hose Clamp
Coupler
Hose Clamp
Figure EE
Figure FF
Waste Tee Installation Disposer Installation
Figure GG
Fasten to underside
of countertop
32"
Min.
18"
Min.
Fasten to underside
of countertop
32"
Min. 18"
Min.
Disposer Installation Waste Tee Installation
Remove
Hopper
Plug