GE 28301 - Manuel (Page 16)

16
back into the base and wall outlet. Reconnect the battery
and charge for 16 hours.
Handset displays "SEARCHING" or "NOT REGISTERED" and
cannot link up with the base when the TALK/CALL BACK
button is pressed.
• Handset may be out of range of the base. Move closer to
the base.
• Make sure the power adaptor is properly installed.
• Disconnect the handset battery and plug it in again. Place
the handset on the cradle for at least  to  minutes.
• Disconnect the power adaptor and plug it in again. Then
place the handset on the cradle for at least  to  minutes.
Handset displays "HANDSET NEEDS REGISTRATION"
• Follow the programming in the telephone procedures to
re-register the handset to the base.
• Press the SELECT button to begin handset registration.
Follow instructions on Handset screen.
Registration did not work
• Charge the batteries for 16 hours.
• Uplug and then plug in the power adaptor.
Caller ID Solutions
No Display
• Charge or replace the batteries.
• Make sure that the unit is connected to a non-switched
electrical outlet. Disconnect the AC power adaptor from
the base and reconnect it.