GE 42 - Manuel (Page 14)

Consumer Support
Tr
oubleshooting T
ips
Operating Instructions
Safety Instructions
Installation Instructions
14
Replacing the light bulbs.
Setting the controls to OFF does not remove power to the light circuit.
Refrigerator Compartment—Upper Light
Raise the grille panel, set the master
power switch to the O (off) position and
allow lamps to cool.
To remove the light shield, press on the
sides of the shield and pull down.
Replace the bulbs with appliance bulbs
of the same or lower wattage. Replace
the shield by engaging the bottom tab
into the slot and applying light forward
pressure until the shield snaps in place.
Set the master power switch to the I (on)
position and close the grille panel.
Refrigerator Compartment—Lower Light
This light is located above the top drawer.
Raise the grille panel, set the master
power switch to the O (off) position and
allow lamps to cool.
Remove items from the shelf above the
light shield. Remove the shelf.
Use both hands to grasp each end of
the light shield. Press in on the bottom
of the shield with your thumbs while
rotating the cover up and out.
Replace the bulb with an appliance
bulb of the same or lower wattage.
Replace the shield by engaging the
bottom tab into the slot and applying
light forward pressure until the shield
snaps in place.
Set the master power switch to the I (on)
position and close the grille panel.
Freezer Compartment
Raise the grille panel, set the master
power switch to the O (off) position and
allow lamps to cool.
Remove the items from the shelf just
below the light shield. Remove the
shelf.
To remove the light shield, press down
on the top of the shield and pull the
tabs out of the slots. Tilt the shield
forward and out.
Replace the bulb with an appliance
bulb of the same or lower wattage,
and reinstall the light shield. Replace
the shield by engaging the bottom tab
into the slot and applying light forward
pressure until the shield snaps in place.
Set the master power switch to the I (on)
position and close the grille panel.
Dispenser
Raise the grille panel, set the master
power switch to the O (off) position and
allow lamps to cool.
The bulb is located in the dispenser
under the control panel. Remove the
two screws from the light shield. Slide
the light shield toward the dispenser to
disengage the tabs, then remove the
light shield. Remove the light bulb by
turning it counterclockwise.
Replace the bulb with a bulb of the
same size and wattage. Replace the
light shield by sliding the tabs into
the slots in the front of the dispenser.
Replace the two screws.
Set the master power switch to the I (on)
position and close the grille panel.
(appearance may vary)