Faber Axia Isola Island Mount Canopy Rangehood - Manuel (Page 9)

Version 3/08 - Page 9
• This rangehood uses 20 watt halogen lamps.
Rangehood Control Panel
The control panel is located on top of the rangehood canopy.
The position and function of each control button are indicated
in FIGURE 15.
Light On/Off Button ( L )
On/Off switch for the halogen light. Move the switch to "1"
to turn the light ON and to "0" to turn it OFF.
Blower On/Off Button ( M )
On/Off switch for the blower. Move the switch to "1" to turn
the blower ON and to "0" to turn it OFF.
Blower Speed Button ( V )
Speed control for blower. Moving the switch to the 1 Position
turns the blower on LOW. Moving the switch to the 2 Position
turns the blower on MEDIUM. Moving the switch to the 3 Position
turns the blower on HIGH.
For Best Results
Start the rangehood several minutes before cooking to develop
proper airflow. Allow the unit to operate for several minutes
after cooking is complete to clear all smoke and odors from
the kitchen.
Cleaning
The stainless steel grease filters should be cleaned frequently in
hot detergent solution or washed in the dishwasher. Stainless
steel cleaner should be used on stainless rangehoods. Abrasives
and scouring agents can scratch stainless steel finishes and
should not be used to clean finished surfaces.
Replacing the Lamps
Before attempting to replace the lamps, make sure that the
light switch is turned off. Remove the 2 screws (as indicated
in FIGURE 16) that hold the light support and gently pull the
support down from the hood. Remove the lamp from the light
support and replace with new lamp. Replace the light support
and fix it into place with the 2 screws.
An alternative method to replace the lamps is to use a 1 1/4"
suction cup (FIGURE 17). Attach the suction cup to the bulb and
pull firmly down on the bulb and replace with a new lamp.
WIRING DIAGRAM
FIGURE 16
USE AND CARE INFORMATION
This rangehood system is designed to remove smoke, cooking
vapors and odors from the cooktop area.
Rangehood Control Panel
The control panel is located on top of the rangehood canopy.
The position and function of each control button are indicated
in FIGURE 15.
1 2 3 1 2 1 2
L M V
FIGURE 15
FIGURE 17