Faber MATRIX Wall Mount Luxury Rangehood - Manuel (Page 9)

Version 07/11 - Page 9
USE AND CARE CONTINUED - MAINTENANCE
Replacing the Lamps
Remove the light cover (as indicated in FIGURE 14) by
removing the screws on the light bar. Remove the lights from
the housing and replace the lamp with a 20 W MR-11 halogen
lamp. Make sure that the two pins are properly inserted into
the lamp holder socket. Replace the light cover.
An alternative method to replace the lamps is to use a 1
1/4" suction cup (FIGURE 15). Attach the suction cup to
the bulb and pull firmly down on the bulb and replace with
a new lamp
FIGURE 14
WIRING DIAGRAM
• This rangehood uses 20 watt halogen lamps.
FIGURE 15
Grease Filter and Charcoal Filter Alarm Reset
When "FF" message appears on the LED screen, the metal
grease filters need to be washed in the dishwasher. To reset
the metal grease filter alarm and the charcoal filter saturation
alarm, turn off the motor and lights. Next, press and hold the
24 hour button "E" until the filter message disappears.
Charcoal Filter Information
The charcoal filters should be replaced (as indicated in FIGURE
7 on page 8) when the "EF" message appears on the LED screen
or at least every 4 - 6 months depending on heavy usage. The
alarm only comes on when the motor is turned on.
To replace the charcoal filter, open the ducting panels, remove
the metal grease filters and remove the old charcoal filters and
replace with the new ones. Then replace the metal grease filters
and close the ducting panels.
Charcoal Filter Alarm Activation
The filter alarm has to be activated in order to use with ductless
installations which use the charcoal filters. The alarm can be
activated upon installation or at a later time. To activate or de-
activate the alarm turn off the motor and lights, and disconnect
the hood from the power source. Press and hold the "B" button
and while holding down the "B" button, reconnect the power
source. Two rotating rectangles will then show on the LED screen
and within 3 seconds press and hold the "B" button LED screen
shows a confirmation of the chosen setting below:
"EF" flashes twice - Charcoal filter saturation alarm ENABLED
"EF" flashes once - Charcoal filter saturation alarm
DISABLED
Repeat the process if you want to change the chosen setting, ie if
the filter alarm is disabled, repeat the above paragraph to enable.
Once finished with the activation / de-activation, unplug and plug
in again the power source to return to normal hood function.
I Schema Elettrico NL Schema Electrisch
GB Electric Diagram E Esquema Eléctrico
F Schéma Electrique Esquema Eléctrico
D Schema Elektrisch
I Schema Elettrico NL Schema Electrisch
GB Electric Diagram E Esquema Eléctrico
F Schéma Electrique Esquema Eléctrico
D Schema Elektrisch
PT PT
436003384 SF5_023 r- 436003384 SF5_023 r-