Faber MATRIX Wall Mount Luxury Rangehood - Manuel (Page 6)

Version 07/11 - Page 6
PREPARE THE WALL
1. Disconnect and move freestanding range from cabinet open-
ing to provide easier access to rear wall. Put a thick, protective
covering over cooktop, set-in range or countertop to protect from
damage or dirt.
2. Determine and clearly mark with a pencil the center line on the
wall where the rangehood will be installed.
3. Draw a horizontal line at 43" above the cooktop (as indicated
in FIGURE 4). Mark two points (1) (in FIGURE 4) on the horizontal
line, 7 7/8" away from the center line on each side. Make sure both
marks are level.
4. Mark two points (2) (in FIGURE 4) which are 19 7/16" above
the cooktop, and are 7 1/16" on either side of the center line. Make
sure both marks are level.
FIGURE 5
5. In holes (1) (in FIGURE 4) attach the two mounting brackets
(B) to the wall with 2 mounting screws.
6. In holes (2) (in FIGURE 4) put one safety screw (G) in each
hole, do not tighten the screws all the way.
B
F
G
FIGURE 4
INSTALL THE RANGEHOOD
1. Open the ducting panels on the rangehood. Disconnect the 4 pan-
els from the hood by sliding the fixing pin lever (as indicated in (A)
FIGURE 5).
2. Using two hands, remove the grease filters one at a time by pushing
the filter forward and and pulling the handle down. (FIGURE 6)
3. Adjust the two adjusting screws on the mounting hardware (B in
FIGURE 5) to the lowest point
4. Hang the rangehood on the two mounting screws and from the
inside of the hood, adjust the mounting screws to make the hood level
(B in FIGURE 5).
5. Tighten the safety screws (Hole 2, in FIGURE 4)
6. For ducted installations, the DAMPER (I in FIGURE 1) must be at-
tached to the exhaust opening at the top of the CANOPY SECTION.
Connect the ductwork and seal all connections with duct tape.
FIGURE 6
FOR ALL INSTALLATIONS
1. Remove the cover from the Field Wiring Compartment with
a phillips screwdriver. Feed the Power Supply Cable through
the electrical knockout (located on back of the hood, FIGURE
7). Connect the Power Supply Cable to the rangehood cable.
Attach the Power Supply Cable grounding lead to the green
screw provided. Attach the White lead of the power supply to the
White lead of the rangehood with a twist-on type wire connector.
Attach the Black lead of the power supply to the Black lead of
the rangehood with a twist-on type wire connector. Using the
4 holes provided screw the Field Wiring Compartment to the
wall as dictated by your Power Supply Cable location (screws
not provided). Replace the cover.
WARNING: THE SCREWS PROVIDED FOR MOUNTING THIS
RANGEHOOD MUST BE INSERTED INTO SOLID WOOD. THESE
MUST NOT BE INSERTED INTO SHEET ROCK.
15"
19 7/16"
43"
FIGURE 7
7 7/8"
9 7/16"