Hunter Fan 37203 - Manuel (Page 4)

43000-01 06/02/2006 © 2006 Hunter Fan Company 4
1. Remove the Care Free ® Warm Mist Humidifier
from its packaging.
2. Select a location for your humidifier. The
location should be flat, hard, water-resistant,
and at least six (6) inches away from walls
and sources of heat. Mount the humidifier
on a drip tray if you are using the unit on a
wood surface or other surface which could
be damaged by accidental water spillage or
condensation.
HUNTER WILL NOT ACCEPT RESPONSIBILITY
FOR DAMAGE DUE TO WATER SPILLAGE.
3. Place the Base in the location you selected.
Take the Water Tank to a sink or tub to fill
with water.
4. Unscrew the Tank Cap by twisting it
counterclockwise and fill the Water Tank with
fresh, cool water. NEVER USE HOT WATER.
5. Replace the Tank Cap by screwing it clockwise
onto the Water Tank.
6. Place the Water Tank back onto the Base.
Make sure the Water Tank is properly seated
on the Base or the humidifier will not work
properly.
HUNTER WILL NOT ACCEPT RESPONSIBILITY
FOR DAMAGE DUE TO WATER SPILLAGE.
7. Make sure the Power Button is set to OFF and
plug the humidifier into the wall outlet.
CAUTION: Never plug in the humidifier
while your hands are wet, as electric shock
could occur.
NOTE: Let the humidifier sit for one minute after
refilling the tank, before turning
the power back ON.
8. Push the Power Button to turn the humidifier
ON. Adjust the setting as needed.
Base
Water
Tank
43000_WM MechHum_06.02.06.indd 6/2/06, 11:15 AM 4