Emerson CKD3630C - Manuel (Page 3)

4
PREPARATION FOR USE
UNPACKING AND SET UP
• Carefully remove the unit from the display carton. Remove all the packing material
from the unit and remove any small strips of tape that may have been used to
prevent the CD door from opening in transit.
• Unwind and extend the FM lead wire antenna.
• This unit was shipped with a dummy CD transit card in the CD player. This
dummy CD prevents the laser pick up from moving during shipment. This card
must be removed before you can insert your own CDs. Raise the CD door,
remove the transit card and discard it.
• Place the unit on a flat, level surface such as a table, desk, counter, shelf, etc,
convenient to a 120V 60Hz AC outlet, out of direct sunlight, and away from
sources of excess heat, dust, moisture, or strong magnet fields.
PROTECT YOUR FURNITURE
This model is equipped with non-skid rubber 'feet' to prevent the product from
moving when you operate the controls. These 'feet' are made from non-migrating
rubber material specially formulated to avoid leaving any marks or stains on your
furniture. However certain types of oil based furniture polishes, wood preservatives,
or cleaning sprays may cause the rubber 'feet' to soften, and leave marks or a
rubber residue on the furniture. To prevent any damage to your furniture we strongly
recommend that you purchase small self-adhesive felt pads, available at hardware
stores and home improvement centers everywhere, and apply these pads to the
bottom of the rubber 'feet' before you place the product on fine wooden furniture.
5
BATTERY BACK UP SYSTEM
This model includes a battery back up circuit that will maintain the clock and alarm
settings in the event of a temporary power interruption. The battery back up system
requires one 9-Volt battery, not included. The battery compartment is located on
the back of the cabinet.
1.) Press the battery door-locking tab in the direction of the arrow and remove the
battery door.
2.) Connect a fresh 9-Volt alkaline battery to the battery terminal in the battery
compartment. It can only be connected one way.
3.) Replace the battery door.
If the power is interrupted the display will go off and the radio will not work. However
the battery will maintain the clock and alarm settings in memory. When the power
is restored the display will come on again and the clock and alarm settings will be
correct.
The life of the back up battery will depend on the frequency and length of the
power interruptions that you experience. For best results we suggest you install a
fresh battery every 9 to 12 months. Always use a well-known brand of alkaline
battery.