Electrolux EDC 77550W - Manuel (Page 17)

Programme information
Adjusting the level
of conductivity
Water contains, a variable quantity of limestone and mineral salts
of which quantities vary according to geographical locations thus
varying its conductivity values.
Relevant variations of the conductivity of the water compared to
those prefixed by the factory could slightly influence the residual
humidity of the laundry at the end of the cycle. Your dryer allows
you to regulate the sensitivity of the drying sensor based on
conductivity values of the water by using the following procedure.
T To o a ac cc ce es ss s a ad djju us sttm me en ntt m mo od de e::
1. Turn the programme selector dial to switch on the appliance.
2. In selection mode,press simultaneously the buttons
D
Drry yn ne es ss s and S Stta arrtt//P Pa au us sa a.
Press the buttons down until until «C0» appears on the digits.
A Ad djju us sttiin ng g tth he e lle ev ve ell o off c co on nd du uc cttiiv viitty y:
Press the S Stta arrtt//P Pa au us sa a button sequentially: the level of
conductivity is indicated by the lighting of the horizontal
hyphens.
Display Conductivity Approximate value µS/cm
C CO O Low < 300
C CO O Medium 300-600
C CO O High >600
Normally, the appliance is factory-set to the highest level;
however, certain models may be configured differently.
M Me em mo orriiz ziin ng g tth he e n ne ew w s se ettttiin ng g::
Simultaneously press the buttons D Drry yn ne es ss s and S Stta arrtt//P Pa au us sa a.
Press the buttons down until the previous drying cycle time
appears again on the display and the buzzer sounds.
O = Cancelling/OFF
To reset a programme and to switch off the machine turn
the selector dial to O. Now can a new programme be
selected.
Objective Implementation
GB
programme information electrolux 17