Emerson NR290TTC - Manuel (Page 4)

3
IMPORTANT NOTES
Avoid installing this unit in places
exposed to direct sunlight or close to
heat radiating appliances such as
electric heaters, on top of other stereo
equipment that radiates too much heat,
places lacking ventilation or dusty areas,
places subject to constant vibration and/
or humid or moist areas.
Do not attempt to clean this unit with
chemical solvents as this might damage
the finish. Use a clean dry cloth.
Operate controls and switches as
described in the manual.
Before turning On the power, make
certain that AC power cord is properly
installed.
, ,
Store your Cds, cassettes in a cool
area to avoid damage from heat.
When moving the set, be sure to first
disconnect the power cord.
CLASS 1 LASER PRODUCT
CLASS 1 LASER PRODUCT
APPAREIL A LASER DE CLASSE 1
PRODUCTO LASER DE CLASE 1
CAUTION
INVISIBLE LASER RADIATION
WHEN OPEN AND INTERLOCKS
DEFEATED.
AVOID EXPOSURE TO BEAM
This product contains a low power Laser Device.
FCC INIFORMATION
This equipment has been tested and found to comply with the limits for a Class Bdigital
device, pursuant to Part 15 of the FCC Rules. These limits are designed toprovide
reasonable protection against harmful interference in a residentialinstallation. This
equipment generates, uses, and can radiate radio frequency energyand, if not installed and
used in accordance with the instructions, may cause harmfulinterference to radio
communications. However, there is no guarantee thatinterference will not occur in a
particular installation. If this equipment does causeharmful interference to radio or television
reception, which can be determined byturning the equipment off and on, the user is
encouraged to try to correct theinterference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which thereceiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing
two conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that
may cause undesired operation.
(1)
(2)
Changes or modifications not expressly approved by the party responsible for compliance
could void the user
s authority to operate the equipment.