Motorola Talkabout T110 Alkaline Two-Way Radio (3-Pack, Green/Blue/Orange and White) - Manuel (Page 12)

10
English
Adjusting the Sound (Key Beeps)
Your radio emits a beep each time one of the buttons is
pressed (except the PTT button).
Press and hold the button while turning the radio on to
switch the sound off.
To turn this sound on, turn the radio off and on again without
pressing the
button.
Selecting a Channel
In order to speak to someone, both your radios must be set
to the same channel.
To select a channel:
1. Press
/ button until the Channel number starts to
flash.
2. Press or button to the required channel. An
extended press of or button allows you to scroll
through the channel.
3. Press PTT button to confirm the selection or /
button to continue setup.
Talking and Listening
To communicate, all radios in your group must be set to the
same channel.
1. To talk, press and hold the
PTT button. When
transmitting, the icon is shown.
2. When you are finished talking, release the PTT button.
3. When receiving, the icon is shown.
For maximum clarity, hold the radio 1 in. away from your
mouth and speak directly into the microphone. Do not
cover the microphone while talking.
Talk Range
Your radio is designed to maximize performance and
improve transmission range. Do not use the radios closer
than 5 ft apart.
Push-to-Talk Timeout Timer
To prevent accidental transmissions and save battery life,
the radio emits a continuous warning tone and stops
transmitting if you press the PTT button for 60 s
continuously.
Channel Scan Mode
Channel Scan Mode enables your radio to scan for active
channels. When activity is detected, your radio lands (stays)
on that channel (for two seconds). To transmit on that
channel, press the PTT button. When activity on the landed
channel ends, your radio continues scanning other
channels.
To turn the channel scan on:
1. Press
/ button two times until icon appears.
2. Press / button to start scanning. Press /
button or PTT button to turn off Scan mode.
T11X.book Page 10 Wednesday, December 16, 2020 11:13 PM