Silvercrest SDBC 3.5 A1 - Manuel (Page 61)

58
Water drops from the
iron soleplate .
The iron soleplate
is dirty or it stains the
clothes.
Steam comes out of
the iron permanently.
Dirty water comes out
of the iron.
Steam comes out of
the saftey cap .
The temperature of the
soleplate is too low or
the steam setting too
high.
Condensed water
remained in the iron
cord , because you
are using the ironing
)"*+'"#$.'#+T"#Q'=+#+(I"#
or after a long break.
The steam button
has been pressed for a
long time or permanent
steam has been used for
a long time.
The temperature setting
is too high.
The lock slider on the
steam button
is activated.
There is too much lime-
scale in the boiler or the
iron.
Some kind of addictive
has been mixed to the
water.
The safety cap is not
Q'I5O#)5.="3K
The o-ring is faulty.
Check steam and tem-
perature settings with
table in chapter 9.
Press the steam supply
button till you get
steam.
Press the steam button
only for a short time
when needed.
Turn the temperature
%3R-=+I"*+#l*.&##
to a lower setting.
Release the lock slider
on the steam button .
Decalcify the boiler and
the iron.
Contact the costumer
service.
Close the safety cap
correctly.
Contact the costumer
service.
PROBLEM REASON SOLUTION
Water drops from the
iron soleplate . 13
Close the safety cap 1 The safety cap is not 1
the saftey cap . 1
cord , because you 21
Turn the temperature
%3R-=+I"*+#l*.&## 11
13
steam button 12 on the steam button . 12
Press the steam supply
button till you get 12
The steam button 12 Press the steam button 12