Livarno 102631-14-01 - Manuel (Page 7)

7 GB/IE
CAUTION! EXPLOSION
HAZARD! Never recharge non-
rechargeable batteries, do not
short-circuit and / or open batteries!
Never throw batteries into fire or water!
Do not exert mechanical loads to batteries!
Risk of battery leakage
In the event of a battery leak, immediately
remove it from the device to prevent damage!
Avoid contact with the skin, eyes and mu-
cous membranes! In the event of contact with
battery acid, thoroughly flush the affected
area with plenty of clean water and seek
immediate medical attention!
Avoid extreme environmental conditions and
temperatures, which could affect batteries,
e.g. above radiators / in direct sunlight.
Remove the batteries from the device if they
have not been used for a long period!
Risk of equipment damage
Only use the specified battery type!
When inserting the battery ensure that it is
inserted the right way round! This is shown
in the battery compartment!
If necessary, clean the battery and device
contacts before inserting the battery!
Remove dead batteries from the device
immediately!
Start-up
Lamp
Before first use, screw the included lamp 1
into the E27 socket of a light. When doing
this, ensure that the lamp is securely seated.
Note: The lamp has a weight of approx.
100 g and measures approx. 6 x 11 cm.
Verify the lamp may be used with the
respective light before use.
Connect the lamp used to the mains and
switch it on.
Remote control
Before first use, remove the battery insulat-
ing strip between the battery 16 and the
battery compartment 13 of the remote
control 2 .
Press the ON button 6 on the remote
control to switch the lamp on (Fig. A).
Note: Please note the remote control uses
infrared lamp: it does not allow the signal
to be transmitted „around the corner“ as
radio waves do. Light-tight objects may not