Eton ego4000 - Manuel (Page 11)

P O W E R I N G T H E U N I T
You can power the unit from any of these power supplies:
• Four AA alkaline batteries.
• Standard AC power using a DC 7.5V, 800mA AC/DC adapter.
Note: The batteries are disconnected automatically when an AC/DC adapter is
connected to the unit.
USING BATTERIES
Caution:
• Always use fresh batteries of the required size.
• Do not mix old and new batteries, different types or brands of batteries or
rechargeable batteries of different capacities.
Follow these steps to install batteries:
1. Press down and slide open battery door in the direction of the arrow and lift
it up.
2. Place four AA batteries into the compartment as indicated by the polarity
symbols (+ and -) marked inside.
3. Close the battery door.
Cautions: 1) When “ ” flashes on the display, sound distorts or volume
weakens, replace the batteries.
Note: When batteries are taken out, the clock will be kept for about 3 minutes.
Please replace batteries quickly to prevent clock setting being cleared.
2) If you do not plan to use the unit with batteries for a month or more, or if
you plan to use only AC/DC adapter, remove the batteries. Batteries can leak
chemicals that may destroy electronic parts.
3) Dispose of old batteries promptly and properly. Do not burn or bury them.
USING AC POWER
You can power the unit from a standard AC outlet by using a DC 7.5V 800mA
AC/DC adapter.
Note: Once an AC/DC adapter is connected to the unit, the batteries
pre-installed will be disconnected automatically.
Follow these steps to connect an AC/DC adapter to the CD player:
Insert the AC/DC adapter’s plug into the units DC IN 7.5V jack.
Plug the other end of the adapter into a standard AC outlet.
Caution: When you finish using the AC/DC adapter, disconnect it from the AC
outlet first, then unplug it from the unit.
12