Epson Stylus NX530 - Manuel (Page 23)

Solving Problems 23
■ Make sure that the product is within range of your router or access point.
■ If your wireless router or access point doesn’t broadcast its network name (SSID),
manually enter your wireless network name. If your wireless router or access point has
wireless security enabled, you will also need to know what kind of security it is using.
The product does not appear in the printer window
(Mac OS X)
Make sure the printer driver was installed correctly and that your computer’s TCP/IP
settings are configured correctly.
Cannot print over the network
■ Print a Network Status Sheet (see page 24) and verify that the network settings are
correct.
■ If your network does not assign IP addresses using DHCP, you need to set the IP
address manually.
■ For an Ethernet connection, make sure that the product is turned on, and that your
router, access point, switch, or hub link LED for the port the product is connected to
is on or flashing. If the link LED is off, try the following:
■ Make sure the Ethernet cable is securely connected to both the product and your
router, access point, switch, or hub.
■ Try connecting to another port on your router, access point, switch, or hub.
■ Try connecting the product to another router, access point, switch or hub.
■ Try connecting the product to your router, access point, switch, or hub with
another Ethernet cable.
■ Try printing from another computer on the network to see if the problem
persists.
■ Turn off the firewall.
The product’s WiFi light is on but you can’t print
■ Make sure your firewall or security software is not set to block port 3629 (TCP/
UDP). Contact your firewall manufacturer for assistance.
■ Make sure the correct printer driver is selected as your default printer.