Epson Stylus NX530 - Manuel (Page 21)

Maintaining Your Product 21
4. Squeeze the tab on the cartridge and lift it up. Dispose of
it carefully. Do not take the used cartridge apart or try to
refill it.
Warning: If ink gets on your hands, wash them
thoroughly with soap and water. If ink gets into your
eyes, flush them immediately with water. Keep ink
cartridges out of the reach of children and don’t drink
the ink.
5. Before you open the new cartridge package, shake it gently four or five times. Then
remove it from the package.
6. Remove the yellow tape from the bottom of the ink
cartridge.
Caution: Do not remove any other labels or seals, or
ink may leak. Do not touch the green chip on the front
of the cartridge. This can damage the ink cartridge.
7. Insert the new ink cartridge into the holder and push it
down until it clicks into place.
8. Once you replace all the cartridges that need replacing, close the cartridge cover and
push it down until it clicks into place.
9. Close the scanner to begin charging the ink. This takes about 2 1/2 minutes. When
you see a completion message on the LCD screen, ink charging is finished.
Caution: Never turn off your product while ink is charging or you’ll waste ink. If you
see an ink replacement message on the display screen, press OK and press down
all the cartridges securely. If you remove a low or expended ink cartridge, you
cannot reinstall and use the cartridge.