Curtis SBT235 - Manuel (Page 4)

4 5
EN
During talking, press the Multifunction Button again to end or disconnect the call.
4. Redialing
Press the Multifunction Button twice in rapid succession to redial the last dialed number.
5. Volume Control
When listening to music or on a call, you can adjust volume by pressing the VOL + or VOL-
Button accordingly.
Automatic Pairing
After powering off your headset, press and hold the Multifunction Button. Release the button
when the light flashes green. Do not press and hold until you see the light flash green and
red.
At this time, if the headphone did not complete pairing with any equipment in range, it
will automatically enter device search status. Next time your device turns on, you will
automatically be paired with this headset. If this does not happen, you may have to re-pair
your device.
Following instructions in “Pairing the Headphones” to pair.
Reconnecting
After the headphones and your device disconnect, the headphone will enter standby status.
The indicator light will flash red. Press the Multifunction Button and the headphone will
automatically reconnect.
Troubleshooting
1. If the Bluetooth does not function of power off after powering on, the headset is low in
power and needs to be recharged.
2. Headset and pairing device need to be within 16 feet of each other with no major
obstacles in order to pair.
3. If the device paired successfully, but there is no sound.
a. Check to make sure the device and headset are connected correctly.
b. Check weather volume is set at minimum.
c. Delete all paired Bluetooth devices from your device and pair the headset again.
4. Your headset is making unwanted noises:
a. Make sure the devices are within effective operating distance and no obstacles
are blocking the signal. If anything is blocking the signal, the sound may distort or be
fragmented in your headset.
b. The constant beep may be the low battery warning.
5. Some mobile devices support Bluetooth communication but do not support Bluetooth
music streaming.