Curtis SBT235 - Manuel (Page 3)

2 3
EN
Turning Headphones ON/OFF
Power ON: Press and hold the Power ON/OFF button for 10 seconds until the LED flashes
blue.
Power OFF: Press and hold the Power ON/OFF button for 3 seconds. The blue LED light
will flash three times and then the headphones will turn off.
Pairing the Headphones
1. Ensure the headphones are turned off. If not, turn off the headphones first before pairing.
2. Press and hold the Power ON/OFF button for 10 seconds until he LED flashes Blue. This
will indicate your headphones are now in pairing mode.
3. Place the headphones and the Bluetooth device to which you would like to pair it within
the operating distance. We recommend keeping the two devices no further than 3 feet
apart.
4. Ensure Bluetooth is enabled on your phone or music device. Refer to the manufacturer’s
instructions for how to enable Bluetooth on your device.
5. Once you have activated Bluetooth on your device, select the earphones “Sylvania” from
the list of available Bluetooth devices.
6. Please note, paring mode on the headphones will last for two minutes. If no devices are
paired after two minutes, the headphones will automatically return to standby mode.
7. If pairing is unsuccessful, turn off the headphone first and repair following the
aforementioned steps. Once you have paired the earphones with a device, the automatically
when the device’s Bluetooth is activated and in range. You do not need to re-pair any
previously connected devices.
Listening to Music
Once the headphones are paired to your device, you can stream music wirelessly to the
headphones. Select the track you wish to listen to on your device to listen via earphones.
Should you encounter any problems while streaming, please refer to your device’s user
manual.
Manual Key Functions
Your headphones are equipped with a few shortcut keys. Please note the following
functions.
1. Answering a call
When a call comes in, you will hear a ring tone and the headphones will flash blue press the
Multifunction Button to answer the call. The LED indicator light will turn green to indicate the
call is connected. Press the volume control buttons to adjust volume on your call.
2. Rejecting a call
When a call comes in, to reject the call, press the Multifunction Button twice in quick
succession to reject the call.
3. Ending a call