Curtis FRW482C - Manuel (Page 5)

4
The plug is the only way to unplug the appliance and should therefore be accessible at all times.
To turn off main power to the appliance, detach the plug from the outlet. Do not immerse the
appliance, the power cord or the plug in water or other liquid.
The appliance must be grounded. The manufacturer is not responsible for damages that may
occur as a result of usage without grounding.
INSTALLING THE APPLIANCE
This appliance is designed to be free standing only.
Install the appliance in a dry, well ventilated room. The installation location should neither be
exposed to direct sunlight nor near a heat source, e.g. a cooker, radiator, etc.
To ensure adequate ventilation for the appliance, allow a minimum of 10 cm of airspace on
each side of the cabinet.
For uneven surfaces, front feet can be aligned.
AMBIENT TEMPERATURE
This appliance is designed to operate in ambient temperature between 16°C and 32°C.If these
temperatures are exceeded, i.e. colder or warmer, the appliance will not operate correctly.
MOVING YOUR APPLIANCE
 Make sure that the appliance is unplugged from the mains socket. Remove all bottles and
shelves to avoid any shock.

Always move the appliance vertically.
 After moving, wait for 30 minutes before plugging in the appliance.
Your appliance uses isobutane (R600a) as a refrigerant. Although R600a is an environmentally
friendly and natural gas, it is explosive. Therefore you should be careful during shipment and
installation to prevent your appliance’s cooler elements from being damaged. In the event of a
leak caused by damage to the cooler elements, move your appliance from open flame or heat
sources and ventilate the room where the appliance is located for a few minutes.
BEFORE FIRST USE
 Remove all packaging.
 Clean the inside of the appliance with warm water and a little liquid detergent to remove
manufacturing and transportation dust.