Emerson NR101TTC - Manuel (Page 4)

3
IMPORTANT NOTES
A v o i d i n s t a l l i n g t h i s u n i t i n p l a c e s
exposed to direct sunlight or close to
h e a t r a d i a t i n g a p p l i a n c e s s u c h a s
electric heaters, on top of other stereo
equipment that radiates too much heat,
places lacking ventilation or dusty areas,
places subject to constant vibration and/
or humid or moist areas.
Do not attempt to clean this unit with
chemical solvents as this might damage
the finish. Use a clean dry cloth.
FCC INFORMATION
This equipment has been tested and found to comply with the limits for a Class B digital
d e v i c e , p u r s u a n t t o P a r t 1 5 o f t h e F C C R u l e s . T h e s e l i m i t s a r e d e s i g n e d t o p r o v i d e
r e a s o n a b l e p r o t e c t i o n a g a i n s t h a r m f u l i n t e r f e r e n c e i n a r e s i d e n t i a l i n s t a l l a t i o n . T h i s
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
c o m m u n i c a t i o n s . H o w e v e r, t h e r e i s n o g u a r a n t e e t h a t i n t e r f e r e n c e w i l l n o t o c c u r i n a
particular installation. If this equipment does cause harmful interference to radio or television
r e c e p t i o n , w h i c h c a n b e d e t e r m i n e d b y t u r n i n g t h e e q u i p m e n t o ff a n d o n , t h e u s e r i s
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
O p e r a t e c o n t r o l s a n d s w i t c h e s a s
described in the manual.
Before turning On the power, make
c e r t a i n t h a t p o w e r c o r d i s p r o p e r l y
installed.
Store your phono-records in a cool
area to avoid damage from heat.
When moving the set, be sure to first
disconnect the power cord.
, ,