Epson Perfection R200 - Manuel (Page 16)

16 Notices
■ This product includes a lamp that contains mercury. Please consult your state/
province and local regulations regarding disposal or recycling. Do not put it in the
trash.
■ If you are not going to use the scanner for a long period, be sure to unplug it from the
electrical outlet.
■ Unplug the scanner and refer servicing to qualified service personnel under the
following conditions:
If the power cord or plug is damaged; if liquid has entered the scanner; if the scanner
has been dropped or the case damaged; if the scanner does not operate normally or
exhibits a distinct change in performance. (Do not adjust controls that are not
covered by the operating instructions.)
FCC Compliance Statement
For United States Users
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio or
television reception. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause interference to radio and television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
■ Consult the dealer or an experienced radio/TV technician for help.
WARNING: The connection of a non-shielded equipment interface cable to this
equipment will invalidate the FCC Certification of this device and may cause interference
levels which exceed the limits established by the FCC for this equipment. It is the
responsibility of the user to obtain and use a shielded equipment interface cable with this
device. If this equipment has more than one interface connector, do not leave cables
connected to unused interfaces. Changes or modifications not expressly approved by the
manufacturer could void the user’s authority to operate the equipment.
For Canadian Users
This Class B digital apparatus meets all requirements of the Canadian Interference-
Causing Equipment Regulations.
4870booklet.fm Page 16 Tuesday, December 2, 2003 9:09 AM