Campomatic WD999XE - Manuel (Page 9)

9
GB
OPTIONAL FUNCTIONS
PRE-WASH:
Press this button to obtain a short prewash of maximum temperature 40°C and ap-
proximately 10 minutes duration. This function can only be used on the “ COTTON”,
“ SYNTHETICS” and “DAILY” programmes.
N.B.: When this option is used, the detergent must also be added
to the appropriate pre-wash compartment.
ENERGETIC WASH:
When this button is pressed, the washing machine will run a wash cycle at the set
temperature, though with a longer duration.
The button is enabled for the “ COTTON” and “SYNTHETIC” programmes.
EXTRA RINSE:
The washing machine has been designed to guarantee reduced water consumption.
For sensitive skins, in very soft water areas, or in the case where detergent residues
are noticed at the end of the wash cycle, pressing this button will add one more rinse
to the wash programme.
DRYING:
This button allows the drying time to be selected in minutes, both in automatic mode
(at the end of the wash cycle) and in manual mode (with hand washing). The set time
is that indicated by the lit led. If all the leds are off, the drying cycle will not be effected.
(see table “RECOMMENDED DRYING QUANTITIES ANDTIMES”).
N.B.: The use of the optional functions depends on the type of programme
selected. Consequently, if the wash programme does not include the function,
the button cannot be enabled (see PROGRAMME TABLE”.
USING THE WASHER/DRIER:
USING THE DRIER:
The drying cycle can either be programmed to run automatically at the end of the “ Cotton” and “Syn-
thetics” wash programmes, or it can be started manually (in the case of hand washing, for example)
by rotating the selector to the appropriate position. Before selecting the manual drying function, the
washing must fi rst be spun at a minimum speed of 800 rpm, either in automatic mode or manually, in
that in order to carry out the drying, the time must be selected by pressing the appropriate button. (see
table
“RECOMMENDED DRYING QUANTITIES AND TIMES”)
CONTINUOUS WASH/DRY PROGRAMME
(COTTON AND SYNTHETICS
:
Place the washing in the drum (see table “ RECOMMENDED DRYING QUANTITIES AND TIMES”).
Select the required wash program using the programmer knob. Set the required functions using the
various buttons. Select the required drying time by pressing the button with the symbol. Then press
the Start button. When the delay button ( I) is pressed, the wash and dry programme will start after the
programmed delay time. If the washer/drier has not run the drying programme on completion of the wash
and the spin icon and START button are fl ashing this means that the load is too tangled or unevenly
distributed. In this case, open the drum door, remove and separate the items, replace them in the drum
uniformly, close the door and press the Start button.