Campomatic WD999XE - Manuel (Page 8)

8
GB
VARIABLE SPIN:
DELAYED START:
The washing machine is equipped with a function that allows the start of the wash
to be delayed for up to a maximum of 8 hours. The delay time is selected as follows:
each time button ( I) is pressed, the wash will be delayed by 1, 2, 4, 8 hours. Once
start button ( L) has been pressed, either the selected led or button (I) will fl ash
(according to the model) to indicate that the function has been enabled. The wash-
ing machine will now automatically start the wash cycle after having waited for the
number of hours set.
(This function is also useful for users with off-peak electricity).
After all the operations described in points 1 to 8 of paragraph “ WASH CYCLE” have
been carried out, pressing this button will start the wash cycle.
The relative indicator light will light up after approximately 2 -3 seconds to indicate
that the door is locked and the wash programme has started.
START BUTTON:
PROGRAMMER KNOB “STOP”:
The stop function resets the washing machine. If, for any reason, you want to change
the wash programme or add more washing to the load during the wash cycle, simply
place the programmer knob in position “ STOP”. The “START” led will switch off.
Then re-position the knob on the new programme and press the “ START” button.
The machine offers a wide selection of spin speeds that can be selected before star-
ting the wash programme. To change the spin speed, simply press button ( H) until the
value required is displayed. The corresponding led will light up each time the button
is pressed. If the spin is to be excluded, press the button until the led corresponding
to the No Spin symbo l (where present) or No Spin label, lights up.
NB. The maximum spin speed will vary according to the model and is
indicated in the technical characteristics table of the washing machine. The
maximum recommended spin speed for each programme is that displayed
automatically when the wash programme is selected.
Warning!! Only use this function if strictly necessary and then only if the programme to reset
has not been running for more than 3 minutes. Before opening the door after a reset, wait 2
minutes for the locking mechanism to release.
USING THE WASHING MACHINE
Load imbalance check during spinning:
This washing machine is fi tted with a special electronic load balancing control system. Before each
spin, the system makes sure that the clothes are distributed as uniformly as possible in the drum. If
the washing is not distributed uniformly, the fi nal spin speed is reduced for safety reasons, while if
the load is drastically out of balance, the spin is not effected.
OPTIONAL FUNCTIONS
If one of the following buttons is selected, the relative led will light up. If a function button has
been pressed by mistake or is no longer required, the option can be cancelled by simply repress-
ing the button.
STOP
MAX
800
600
500
1 H 2 H 4 H 8 H
END
30
40
90
75
60
40
30
60
40
30
40 30 40
35
ºC
COLD
SILKS - WOOL
RINSES
DRY
DRAIN SPIN
COLD WASH
STOP
DAILY WASH
QUICK
SYNTHETICS DELICATES
WOOL
COTTONS