Campomatic CHW3070 - Manuel (Page 5)

5
CHW3070 / CHW3070S
cord, plug, or any other part of cooler in water or other liquids.
15. Ensure dispenser is unplugged prior to cleaning.
16. Do not move it roughly. Do not incline it over 45°
17. Never allow children to use the dispenser without proper and direct supervision.
Unplug unit to prevent unsupervised use by children.
18. In order to avoid a hazard due to inadvertent resetting of the thermal cutout,
this appliance must not be supplied through an external switching device, such as a
timer, or connected to a circuit that is regularly switched on and off by the utility.
19. Maintenance and repair must be carried out by specialized technicians. It is
extremely dangerous to any person to fix the device or to dismantle it for repairing
purposes other than a qualified technician.
20. Do not let the power plug dangling over the edge in the reach of children.
5. CARE & CLEANING
Note: Do NOT use abrasive materials or chemical cleaners.
1. Clean cabinet surfaces with a soft cloth and warm soapy water. Dry it with a cloth
2. Brush off dust from the radiator (12) located at back of dispenser to improve
efficiency.
6. CLEANING COLD TANK
Recommended to be done every 2 to 3 months depending on the water type
1. Best to do prior to loading a fresh bottle
2. Turn off both switches on back
3. Unplug power cord
4. Remove water bottle
5. Place at least a 10 Litre bucket under the drain of the dispenser (found on the
back side)
6. Remove drain cap and silicon plug. Cold water will flow into the bucket. This
will be followed several seconds later by hot water at temperatures that can cause
severe burns. Avoid direct contact with hot water.
7. Place drain cap and silicon plug in a safe location so they are not lost.
8. Keep children away while draining the dispenser
9. Remove remaining water from the reservoirs by dispensing from both taps
10. Replace silicon plug and drain cap
11. Remove water guard (1) assembly by turning it counter clockwise.
12. Clean water guard assembly with a soft cloth using a cleaning mixture with 2%
cooking citric acid and 5 litres of clean water and then rinse the water guard and
place it on a clean cloth.
ENG