DCS Professional Warming Drawer WDT-30 - Manuel (Page 9)

7
MOUNTING INSTALLATION
The lower rear corners of the cabinet need to provide proper support to the back of the Warming Drawer and
the anti-tip mounting clips. A 120 volt AC outlet should be located no further than 36 inches from the back
center of the Warming Drawer.
The bottom rear section of the cabinet should be made of solid plywood or two 2x4 beam. It holds the anti-
tip mounting clips and supports the weight of Warming Drawer, which is 90 lbs. (see Fig. 05 and 06). If two
2x4 beams are used, the distance between their centers must be 20” to be able to secure the Warming Drawer.
STEP 1
Use the screws provided and attach the mounting clips. They must be installed for anti-tip safety to the
bottom support at the back. See placement dimensions in figure below (see Fig. 06 and 07).
STEP 2
Plug power cord into AC outlet. Slide the body onto the anti-tip mounting clips (see Fig. 07).
STEP 3
Use the two supplied 1-1/2” long screws through the two embossed holes (see Fig. 08) to secure the front of
the Warming Drawer.
INSTALLATION INSTRUCTIONS
Slide body
on to Anti-Tip
mounting clips
mounting clips
21-1/2"
Fig. 06