DCS Professional Warming Drawer WDT-30 - Manuel (Page 8)

6
INSTALLATION INSTRUCTIONS
SPECIFICATIONS
The cabinet depth from the outer edge of the face frame to the inside back of the cabinet or wall should be at
least 24” (see Fig. 02).
The Warming Drawer should be installed into a base cabinet with minimum outside dimensions of 13-1/4” high
by 30” wide by 24” deep.
Power supply required: 120Volts AC; 5 amp min., 15 amp maximum circuit requirement.
1-1/2" min.
to bottom
of
countertop
A 120 volt AC GFI
outlet should be
located below the
Warming Drawer
2x4's or similar
support
10 1/16" +
–
25-3/4 1/16" +
–
24" >
–
20"
10-1/2"
29-11/16"
23-1/2 "
25-1/16 "
28-3/16 "
POWER
CORD
9-3/4 "
1/4 "
1/2 "
Fig. 02
Fig. 03
Fig. 04
CUT OUT DIMENSIONS WARMING DRAWER DIMENSIONS
(FRONT VIEW)
WDT-30 DIMENSIONS
(SIDE VIEW)
POWER
CORD
1/2 "
1/4 "
23-1/2 "
24-1/8 "
9-3/4 " 8-5/16 "
WDTI
(SIDE VIEW)
Fig. 05