Paradigm SUB 2 - Manuel (Page 33)

28
4. At the selected outlet location, using the black and white wires for power,
install a 15-amp 240-volt receptacle which looks like the receptacle
shown here in the picture at right;
5. Locate the appropriate circuit wires in the breaker panel and disconnect
both the hot wire from the circuit breaker and the white wire from the
neutral buss. Put red tape on the neutral wire;
6. Install a 2-pole 15-amp circuit breaker in the panel;
7. Attach the black and white circuit wires to the 2-pole breaker, one
wire per pole;
8. Restore power to the circuit;
9. Replace the breaker panel cover.
This is the same type
of receptacle used for
many 240-volt window air
conditioners
CONNECTING SUB 2 TO A 240-VOLT LINE
(continued)