Danby DPA085B1GB - Manuel (Page 9)

Features
1 ELECTRONIC CONTROL
INSTRUCTIONS MODE select button
Selects the appropriate operating mode. Each time you press the but-
ton, a mode is selected in a sequence that goes from AUTO, COOL,
TIMER button
Used to initiate the AUTO ON start time and AUTO OFF stop time pro-
gram, in conjuction with the up arrow & down arrow buttons.
POWER button
Turns power on/off.
SLEEP button
Used to initiate the SLEEP operation.
FAN button
UP and DOWN buttons
Used to adjust (increase /decrease) temperature settings (1°C/2°F
increments) in a range of 17°C(62°F) to 30°C(86°F) or the TIMER set-
ting in a range of 0~24hrs. The control is capable of displaying
temperature in degrees Fahrenheit or degrees Celsius. To convert
from one to the other, press and hold the Up and Down buttons at the
same time for 3 seconds.
LED Display
Shows the set temperature in °C or °F and the Auto-timer settings.
While on DRY and FAN modes, it shows the room temperature.
Also displays the following error codes:
E1 - Room temperature sensor error-Unplug the unit and plug
it back in. If error repeats, call for service.
E2 - Evaporator temperature sensor error- Unplug the unit and
plug it back in. If error repeats, call for service.
E4 - Display panel communication error - Unplug the unit and
plug it back in. If error repeats call for service.
P1 - Bottom tray is full - Connect the drain hose and drain the
collected water away. If error repeats, call for service.
2
3
4
5
7
7
6
DRY, FAN and HEAT (not available on cooling only models). The mode
indicator light corresponding to the chosen setting lights up.
Controls the fan speed. Press to toggle between two fan speeds: LOW
(press 1 time) and HIGH (press 2 times). The fan speed indicator light
indicates the corresponding fan setting. Press the button a third time to
initiate AUTO-FAN mode. In this mode, both indicator lights will light up.
E3 - Condenser temperature error - Unplug the unit and plug it
back in. If error repeats call for service.