Danby DPA085B1GB - Manuel (Page 14)

Installation Instructions
INSTALLATION IN A
SLIDING SASH
WINDOW 1. Measure the adhesive foam seal to fit the window stool. Cut the foam
seal (adhesive type) to the proper length and attach it to the window
frame. See Fig.13.
2. Attach the window slider kit to the window stool. Adjust the length of
the window slider kit according to the height of window. Shorten the
adjustable window kit if the height of window is less than 28.3inches.
Open the window sash and place the window slider kit on the window
stool. See Fig.14.
3. Cut the foam seal(adhesive type) to the proper length and attach it on
the top of the window. Shown in Fig.15.
4. Close the sliding sash securely against the window.
5. Cut the foam seal to the appropriate length and seal the open gap
between the top window sash and outer window sash. Shown in
Fig.16.
Foam seal A
(adhesive type)
Fig.13
Fig.14
Window
Panel
Fig.15
Foam
Seal
Fig.16
12
Foam seal
28.34 ~ 81.5