Dolmar Gaoline Chain Saw PS-3410 TH - Manuel (Page 13)

13
45°
45°
= cutting down area
2
1 2
17
18
19
Felling notch
Hinge
Felling cut
Direction of fall
Hinge Felling notch
20
21
22
23
45°
Second cut
First cut
Felling instructions:
First clear the tree base and work area from inter-
fering limbs and brush and clean its lower portion an
When felling, maintain a distance of at least 2 1/2 tree
lengths from the nearest person (see fig. 17).
Note:
The noise of your engine may drown any warning
call.
axe (see fig. 18).
Then, establish a path of escape and remove all obsta-
cles. This path should be opposite to the planned
direction of the fall of the tree and at a 45° angle (fig.
19). An alternate path must also be selected. Place
all tools and equipment a safe distance away from the
tree, but not on the escape path.
Then, determine the placement of the felling notch
(fig. 21). The felling notch when properly placed de-
termines the direction in which the tree will fall. It is
made perpendicular to the line of fall and should be as
close to the ground as possible. Cut the felling notch
to a depth of about one-fifth to one-fourth of the trunk
diameter (fig. 22). It should be in no case higher than
it is deep. Make the felling notch very carefully.
If the tree has large buttress roots, cut into the largest
buttresses vertically first (horizontally next) and remove
(fig. 20).