Poulan 964 77 50-00 - Manuel (Page 8)

4 MOUNTING COVER ASSEMBLY TO
TRACTOR (See Fig. 4)
Use Hardware - - GROUP “C"
MOTE: For ease of assembly, you may wish to obtain the
assistance of another person for mounting assembiy to
tractor.
1. Raise seat on tractor to allow assembly to be
mounted.
2. With cover dosed, lift assembly and place support
post inside mounting bracket. Allow assembly to rest
on lanced tabs of mounting bracket
3. Line up holes in mounting bracket with holes in support
post and insert bracket support pin. Secure with retainer
spring,
4. Unlatch and open cover.
5.
Install the three (3) tubing end caps onto container
support.
6. Tap each end cap onto container support tubes to seat
securely.
CONTAINER ASSEMBLY (See Fig. 5)
No hardware required
Place bottom half inside of top half, as shown.
Place one foot Inside bottom half and lift top half to
meet bottom half.
Press halves tightly together while lifting top to lock
into place as shown.
iMPOBTANTrBEFORELOCKINGTHETABS, HOOKED EDGES
ON BOTH HALVES MUSTOVERUPTO FORM SEAL ASSHOWN
IN INSET.
ASSEMBLY CHECK: Squeeze sides of lower half of con­
tainer and check that there is no gap between upper and
lower halves, if a gap appears, unlock tabs to separate
container halves and repeat instructions above.
8