Stopping engine – Craftsman MGP-670070 Manuel d'utilisation

Page 16

Advertising
background image

16 — ENG

MGP-670070

For recoil start:

Place OFF/RUN/START switch in the RUN posi-
tion.

Grasp handle on rope starter and pull slowly until
resistance is felt. Let the rope rewind slowly. Pull
rope with a rapid full arm stroke. Let rope rewind
slowly. Repeat if necessary.

NOTE: IF ENGINE OIL LEVEL IS TOO LOW, EN-
GINE WILL NOT START. CHECK OIL LEVEL AND
ADD IF NECESSARY.

When engine warms up, gradually push choke
control in to the NO CHOKE position.

IMPORTANT: Allow generator to run at no load
for 5 minutes upon each initial start-up to allow
engine and generator to stabilize.

STOPPING ENGINE

Disconnect all electrical loads.

Turn OFF/RUN/START switch to "OFF" position.

Close fuel shut-off valve.

IMPORTANT: Never store engine with fuel in tank,
indoors, or in enclosed, poorly ventilated areas or
where fuel fumes may reach an open flame.

To Start Your Generator

Never run engine indoors or

in enclosed, poor ventilated areas. Engine
exhaust contains carbon monoxide, an
ordorless and deadly gas.

IMPORTANT: Make sure the battery is properly
serviced, fully charged, and assembled before starting.

Open the fuel shut-off valve.

Pull choke control out to CHOKE position.

NOTE: No choke is required on warm engines. Push
choke control in to start a warm engine.

You MUST unplug any load

from the generator before starting to prevent
permanent damage to any appliances.

For electric start:

Place OFF/RUN/START switch in the START
position.

NOTE: When the engine starts the switch will
remain in the RUN position.

OFF

START

RUN

ARRÊT

MARCHE

DÉMARRAR

OFF

START

RUN

ARRÊT

MARCHE

DÉMARRAR

OFF

START

RUN

ARRÊT

MARCHE

DÉMARRAR

Advertising
Ce manuel est liée aux produits suivants: