Classe Audio CP-700 - Manuel (Page 15)

15
ENGLISH The pin assignments of the XLR-type female input connectors are:
Pin 1: Signal ground
Pin 2: Signal + (non-inverting)
Pin 3: Signal – (inverting)
Connector ground lug: chassis ground
Refer to the operating manuals of your balanced-output line-level sources
to verify that the pin assignments of their output connectors correspond
to the CP-700. If not, wire the cables so that the appropriate output pin
connects to the equivalent input pin.
To achieve the best possible results, we suggest that you use only high-
quality interconnect cables. Please consult with your local Classé dealer for
advice on the best cables for use in your system.
4 Tape output
Connect these RCA jacks to the right-channel and left-channel recording
inputs of your recorder.
These single-ended RCA outputs are unaffected by the volume control
on the front panel, or by whether you choose to monitor the source or
the recorder (by having the “tape” button on the front panel’s touchscreen
deselected or selected, respectively). The record outputs will be disconnected
when the preamplifier is placed into standby, however.
5 Single-ended (RCA) main outputs
Single-ended cables using RCA connectors are the most common form
of analog connection used in consumer electronics. When implemented
carefully and used with high quality interconnect cables, this standard can
provide excellent performance.
Classé has gone to extraordinary effort to ensure that the single-ended
(RCA) outputs of your preamplifier are as good as possible. However, this
connection standard cannot offer the immunity from interference that
balanced interconnection does–hence our recommendation to use the
balanced outputs whenever possible.
If you are not using balanced analog interconnection, then connect these
single-ended outputs to your preamplifier using high-quality shielded
RCA-terminated cables. Your Classé dealer can advise you on the selection
of cables suitable for your system.
6 Balanced (XLR) main outputs
The CP-700 supports two pairs of high quality XLR outputs to provide
balanced stereo analog signal to your power amplifier(s). In most cases, you
will connect one pair only to corresponding balanced inputs on your power
amplifier, using shielded high-quality balanced interconnects. If you choose
to biamplify your speakers, you may need to use both outputs. Your Classé
dealer can provide assistance in selecting appropriate balanced cables for
your system, as well as advice on the potential benefits of biamplification in
your particular situation.