Whirlpool 935 Series - Manuel (Page 27)

Troubleshooting
Before calling for assistance please check the chart below for problems you can fix. It could
save you the cost of a service call.
Dishwasher problems
PROBLEM CHECK THE FOLLOWING
Dishwasher does
not run or stops
during a cycle
Is the door tightly closed and securely latched?
Has the cycle been set correctly?
Is the dishwasher set for a delay start?
Has a household fuse or circuit breaker blown or tripped?
If the motor stopped because of an overload, it will automatically
reset itself within a few minutes. If it does not start, call for service.
Is the water supply turned on?
Is the dishwasher wired into a live circuit with the proper voltage?
Dishwasher
runs too long Cycle times depend on the temperature of the water entering the
dishwasher. Cooler water results in longer cycle times.
Undercounter dishwashers require adequate enclosure for proper
operation. See Installation Instructions for complete information.
Dishwasher
will not fill Is overfill protector stuck in “up" position? Overfill protector should
move up and down freely. Press down to release. See the “Caring
for Your Dishwasher” section, on page 19.
Water remains
in dishwasher
Allow cycle to finish. A small amount of water remaining is normal.
Check the drain air gap (if installed). If it is clogged, follow the
manufacturer’s cleaning instructions.
Detergent remains
in covered section
of dispenser Has the cycle completed?
Is the detergent fresh and dry without lumps? See the “Using the
Dispensers” section, on page 11.
Is the bottom rack in backwards? The rack bumpers must face the
dishwasher door.
Dishes not as dry
as you expected
Is the rinse agent dispenser empty? Using a rinse agent greatly
improves drying.
Do not use Air Dry option on the next load. See the “Setting the
Controls” section, on page 13.
Grinding, grating,
crunching, or
buzzing sounds Has a hard object entered the POWER CLEAN* module? The
sound should stop when the object is ground up.
White residue
appears on front
of access panei Is too much detergent being used? See the “Using the Dispensers”
section, on page 11, for recommended amounts of detergent.
Some liquid detergents develop excess foam and residue on panel.
Try a different brand to reduce foaming and eliminate buildup.
continued on next page
27