Whirlpool 935 Series - Manuel (Page 23)

Saving Energy
Saving energy is important and helps you save money. This section gives you tips on the
best ways to save energy with your dishwasher.
Loading tips
• Wash full loads. Running a half-filled
dishwasher uses the same amount of
electricity and hot water as a fully loaded
machine.
• Load correctly for best washing results.
Incorrect loading may cause poor washing.
You will then need to rewash all or part
of a load.
• Do not prerinse normally soiled dishes.
Select the correct cycle for the load and
use the recommended amount of
detergent.
Cycle and option tips
• Use the Low Energy/China cycle whenever
possible. The cycle uses less hot water
and energy than the Normal Cycle.
• Use 4 Hour Delay Start to run your dish­
washer during off-peak hours. Local
utilities recommend avoiding heavy usage
of energy at certain times of day.
• Do not use the High Temp Wash option
if it is not needed. When this option is off,
if water entering the dishwasher is lower
than 140°F (60°C), the cycle does not take
additional time to heat water during the
main wash.
NOTE: Loads may not wash or dry as well
if the water temperature is too low. For
best dishwashing results, water must be
at least 120°F (49°C) as it enters the
dishwasher.
• Use the Air Dry option whenever possible.
Allow longer drying times (overnight). Use
a rinse agent to improve drying.
To check water temperature:
1. Run hot water at the faucet closest to
your dishwasher. Let the water
run for at least 1 minute.
2. Hold a candy or meat thermometer in
the running stream of water. It
water temperature at the faucet
is below 120°F (49°C), have a
qualified person raise the water
heater’s thermostat setting.
23