Petsafe Drinkwell® 360 Pet Fountain - Manuel (Page 10)

www.petsafe.net 11 10 www.petsafe.net
EN
FR
6. Next, flip the Bowl upside down and unhook the electrical Power Cord from the two
Cord Clips ( fig. 13). This will allow you to pull the electrical Power Cord through
the Cord Pass-Through in the Bowl ( fig. 14).
7. Remove the Pump for cleaning. First remove the Intake Tube by lifting up on the Intake
Tube Holder to free the Intake Tube from the Pump ( fig. 15 & 16). This will allow
you to remove the Pump. The Intake Tube can then be pulled from the Intake
Tube holder.
8. Remove the Foam Filter from the Pump. Clean away any hair, debris or pet food that
may have accumulated on the Faceplate of the Pump (See “Pump Maintenance”
section for detailed cleaning instructions for the Pump).
9. Once the Pet Fountain is completely disassembled you will have 8 plastic parts.
10. Clean the plastic Pet Fountain parts with warm water and soap. You can also put
the Pet Fountain in the top rack of the dishwasher. Remove the Pump before placing
the Pet Fountain in the dishwasher. DO NOT PLACE PUMP IN DISHWASHER!
If possible, it is recommended that you turn down the heat of the water inside
the dishwasher.
11. If you have trouble reaching certain spots or hard-to-reach corners, try using a cotton
swab or purchase the Drinkwell ® Cleaning Kit, a 3-Piece Brush Kit. To purchase a
Cleaning Kit, visit our website at www.petsafe.net to locate a retailer near you or to
find a listing of Customer Care Centre telephone numbers for your area.
fig. 13
Cord Pass-Through
fig. 14
Cord Clips
fig. 15 fig. 16