Vintage Cellars American Series 45 Bottle Wine Refrigerator - Manuel (Page 15)

TROUBLESHOOTING YOUR WINE CELLAR
15
Problem Possible Cause Remedy
Unit not cold enough.
Adjust temperatures (See “Set Tem-
peratures” on page 6).
• Control set too warm.
• Content temperature not stabi-
lized.
• Excessive usage or prolonged
door openings.
• Airflow to front grille blocked.
• Door gasket not sealing properly.
• Adjust temperature colder. Al-
low 24 hours for temperature to
stabilize.
• Allow temperature to stabilize for
at least 24 hours, with minimal
door openings.
• Airflow must not be obstructed to
front grille. See “clearances” on
page 4.
• Check door alignment and/or ad-
just or replace door gasket.
Unit too cold.
Adjust temperatures (See “Set Tem-
peratures” on page 6).
• Control set too cold.
• Door gasket not sealing properly.
• Adjust temperature warmer. (See
page 6, “set temperature”). Al-
low 24 hours for temperature to
stabilize.
• Check door alignment and/or ad-
just or replace door gasket.
No interior light. • Failed light bulb. • Replace light bulb, see page 14.
Light will not go out when door is
closed.
• Door not activating light switch. • Verify cabinet is level, refer to
page 4 for leveling instructions.
• Verify the door is aligned properly,
refer to page 10 for instructions.
Noise or Vibration. • Unit not level. • Level unit, see “Leveling Legs” on
page 4.
Unit will not run. • Unit turned off.
• Power cord not plugged in.
• No power at outlet.
• Turn unit on. See “Start your Appli-
ance” on page 6.
• Plug in power cord.
• Check house circuit.
Before You Call for Service
If the unit appears to be malfunctioning, read through this
manual first. If the problem persists, check the trouble-
shooting guide below. Locate the problem in the guide and
refer to the cause and its remedy before calling for service.
The problem may be something very simple that can be
solved without a service call. However, it may be required
to contact your dealer or a qualified service technician.
Electrocution Hazard
Never attempt to repair or perform maintenance on
the unit until the main electrical power has been
disconnected. Turning the unit control "OFF" does
not remove electrical power from the units wiring.