Care and cleaning of your wine cellar – Vintage Cellars American Series 45 Bottle Wine Refrigerator Manuel d'utilisation

Page 14

Advertising
background image

CARE AND CLEANING OF YOUR WINE CELLAR

Care and Cleaning

Front Grille

Periodically brush and vacuum the front grille area to main-

tain proper air flow through the condenser coil. See page 4,

Figure 1.

Cabinet

The painted cabinet can be washed with mild soap and

water and thoroughly rinsed with clear water. NEVER use

abrasive scouring cleaners.

Interior

Wash interior compartment with mild soap and water. Do

NOT use an abrasive cleaner, solvent, polish cleaner or

undiluted detergent.

Pull-out Racks

The racks may be cleaned with mild soap and water and a

soft cloth. Do NOT use any abrasive cleaners.

Glass Door

Use a glass cleaner or mild soap and water and soft cloth

to clean the glass door model. Do NOT use any abrasive

cleaners.

Door Gasket

The vinyl gasket may be cleaned with mild soap and water,

a baking soda solution or a mild scouring powder.

Light Bulb Replacement

The WES-45 uses one, 15 watt incandescent light bulb to

illuminate the interior of the wine cellar. The light bulb is a

very reliable electrical component, but should it not func-

tion properly, please call the dealer where you purchased

your wine cellar from for a replacement light bulb. Use only

an original equipment light bulb from your dealer or Wine

Enthusiast.

To replace the light bulb, disconnect power to the unit. Un-

screw the old light bulb located behind the display housing

at the top of the unit. Set the old light bulb aside. Screw

the new light bulb into place. Reconnect power to the unit.

Check to see if the light bulb operates properly to complete

the installation.

The light bulb is not covered by your warranty. A replace-

ment bulb can be obtained from your dealer or from Wine

Enthusiast.

In the Event of a Power Failure

If a power failure occurs, try to correct it as soon as possi-

ble. Minimize the number of door openings while the power

is off so as not to adversely affect the unit’s temperature.

14

DISCONNECT THE POWER CORD BEFORE

ATTEMPTING LIGHT BULB REPLACEMENT.

Failure to do so may result in an electrical shock

that could severely injure you.

Do NOT under any circumstance use a light

bulb that exceeds 15 watts!

Advertising