Thetford N81 Series Installation Manual - Current - Manuel (Page 10)

Installation Manual 10
The doors are made to accept decorative panels. The decorative panels must be 3/16 inch or less in thickness. Install
the decorative door panels in the refrigerator doors before installing the refrigerator in the vehicle.
- Make an upper door panel that is 21 19/32 inches wide x 14 17/32 inches high.
- Make a lower door panel that is:
- 21 19/32 inches wide and
- 31 5/8 inches high (for N6XX models) or
- 38 5/8 inches high (for N8XX models).
- Pull the panel retainer [37] off each door (See Art00965).
- Push the decorative door panel [38] into the slots of the door [39].
- Push each panel retainer into the slot on the edge of the door.
Install Decorative Door Panels
- Make sure that the bend of the baffle is the full
width of the inside of the enclosure.
- Make sure that the bend of the baffle is flush with
the bottom edge of the upper intake vent door
frame.
- Make sure that the top edge of the baffle is 1/4
inch [213] below the bottom of the condenser
and that there is 1/4 inch or less clearance [15]
between the rear of the condenser and the baffle.
- If the depth of the enclosure is more than 26 inches
[27], install a wood or an aluminum or galvanized
steel sheet solid box baffle [21] between the lower
intake vent and the upper exhaust vent (See
Art01593).
- Make sure that the solid box baffle is the full width
of the inside of the enclosure.
- Make sure that the bottom of the solid box baffle
is 18 inches to 18 1/2 inches above the bottom of
the enclosure [17] (4 1/4 inches to 4 3/4 inches
above the top of the lower intake vent opening
REF) [18] .
- Make sure that the back of the solid box baffle is
perpendicular to the bottom of the enclosure.
- Make sure that the horizontal top of the solid box
baffle is even with the bottom edge of the upper
exhaust vent [24].
- Make sure that the vertical top edge of the baffle
is between 1/4 inch [213] below the condenser and 1 1/2 inches above the bottom of the condenser.
- Make sure that there is 1/4 inch or less clearance [15] between the rear of the condenser and the baffle.
Art01593 27
17
10
9
18
25
21
24
15 13 15 11
15
213
Art00965
37
38
39
NOTICE