Thetford N3150 Series - Manuel (Page 22)

Installation and Owner’s Manual 22
- When using an upper side-wall exhaust vent:
- If the depth of the enclosure is 20 3/8 inches or more and is less than 22 3/8 inches [27], install a bent aluminum or galvanized
steel sheet baffl e [26] to the rear of the enclosure (See Art02334 and Art02335).
- Make sure that the bend of the baffl e is the full width of the inside of the enclosure.
- Make sure that the bend of the baffl e is even with or below the bottom edge of the upper intake vent door frame.
- Make sure that the top edge of the baffl e is between 1/4 inch [213] below the condenser and 1 1/2 inches above the
bottom of the condenser and that there is 1/4 inch or less clearance [15] between the rear of the condenser and the baffl e.
- For the best cooling performance, the baffl e should be 1/4 inch below the bottom of the condenser.
- If the depth of the enclosure is more than 22 3/8 inches [27], install a wood or an aluminum or galvanized steel sheet solid box
baffl e [21] between the lower intake vent and the upper exhaust vent (See Art02336).
- Make sure that the solid
box baffl e is the full width of
the inside of the enclosure.
- Make sure that the
horizontal bottom of the
solid box baffl e is even with
or above the top edge of
the lower exhaust vent [9].
- Make sure that distance
from the enclosure fl oor to
the vertical bottom edge of
the solid box baffl e [17] is
10 in. for N3104 and 12 in.
for N3150.
- Make sure that the back
of the solid box baffl e is
perpendicular to the bottom
of the enclosure.
- Make sure that the
horizontal top of the solid
box baffl e is even with or
below the bottom edge of
the upper exhaust vent
[24].
- Make sure that the vertical
top edge of the baffl e is between 1/4 inch [213] below the condenser and 1 ½ inches above the bottom of the condenser.
- Make sure that there is 1/4 inch or less clearance [15] between the rear of the condenser and the baffl e.
Reverse the Door Swing (optional)
N3000 series refrigerators are designed so that door swing can be reversed in the fi eld, using kits that can be
purchased separately. Door swing reversal should be done before installing the refrigerator in the vehicle.
NOTICE
Art02336
9
27
10
17
25
21
24
13
14
11
213
15