Drip tray, Metal doors, Glass shelf – Thetford N1095 Series Owners Manual - Current Manuel d'utilisation

Page 9: Door sealing, Refrigerator maintenance checklist, Door sealing refrigerator maintenance checklist

Advertising
background image

Owner’s Manual 9

Drip tray:

To remove and clean the drip tray:

NOTE: Do not wash the drip tray in a dishwasher. The drip tray

is not dishwasher safe.

- Pull the drip tray out of the drain hose.

- Pull the drip tray forward to remove from the slots in the

refrigerator cabinet.

- Clean the drip tray.

- Push the drip tray back into the slots in the refrigerator

cabinet.

- Push the drip tray back into the drain hose.

Metal doors:

To clean the metal doors:

- Wash the doors with a mild cleaner or a solution of liquid dish

detergent and warm water.

- Rinse with clean water.

- Dry with a clean cloth.

NOTE: Do not use abrasive cleaners, chemicals, or

scouring pads because they can damage the

metal doors.

Glass shelf:

To clean the glass shelf:

- Remove the screw and grommet that is in front of the glass

shelf.

- Pull the glass shelf forward out of the slot

- After cleaning, push the glass shelf fully into the slot.

- Put the screw and grommet back in the orignial position.

Door Sealing

Refrigerator Maintenance Checklist

Read and understand the following maintenance sections of this

manual.

NOTE: Norcold is not responsible for installation,

adjustment, alteration, service, or maintenance

performed by anyone other than a qualified RV

dealer or a Norcold authorized service center.

Have a qualified RV dealer or a Norcold authorized service

center do these annual safety and maintenance checks:

- Examine the gas supply lines for leaks.

- Replace or repair if needed.

- Make sure the propane gas pressure is 11 inches of water

column.

- Adjust if needed.

- Make sure the combustion seal is complete and intact.

- Replace or repair it if needed.

- Make sure the burner and the burner orifice are clean.

- Clean if needed.

- Make sure the electrode spark gap is 1/8 - 3/16 inch.

- Adjust if needed.

- Make sure the AC voltage is 108 - 132 volts and the DC

voltage is 10.5 - 15.4 volts.

- Make sure the thermocouple tip is clean and secure.

- Make sure the area at the rear of the refrigerator is free of

any combustible materials, gasoline, and other flammable

vapors and liquids.

Check the seal of the doors.

If either door does not seal correctly, excess frost will collect

inside the refrigerator. Make sure the doors seal correctly (See

Art00980):

- Close each door on a piece of paper that is about the size

and thickness of a dollar bill.

- Gently pull the paper.

- You should feel a slight drag between the gasket and the

cabinet.

- Do this on all four sides of the door.

- If you do not feel a slight drag on the

paper, the door does not seal correctly.

- Have your dealer or an authorized Norcold Service

Center correct the seal of the door.

Advertising