Thetford 2118 Series Installation Manual - Manuel (Page 18)

Installation Manual 18
Before ignition or start up of the refrigerator:
- Make sure the air fl ow in the lower intake vent, through the refrigerator coils and condenser, and out the upper exhaust vent is not
blocked or decreased.
- Make sure there are no combustible materials in or around the refrigerator.
Ignition and start up:
If the gas does not ignite within 30 seconds, the gas valve of the refrigerator will automatically close, the igniter will stop
sparking, an audible alarm will sound, and the fault codes “no” “FL” will fl ash on the LCD [280]. To reset the controls,
press and hold the POWER ON/OFF button [30] for 1 second to turn the refrigerator off and then press it again to
restart the refrigerator (See Art02492).
If the gas does not ignite after several attempts, refer to the “Fault Codes” section of this manual.
Modes of Operation:
1. Push and release the POWER ON/OFF button [30]
2. Select the mode of operation.
- Push and hold the MODE button [31] to scroll through the available operation modes of the refrigerator, one after the other.
- When the desired mode indicator comes on in the LCD, release the MODE button.
- Or push and release the MODE button again and again to change the available operation modes of the refrigerator, one at a time.
- As you change the mode, the applicable mode indicator will come on.
Ignition and Start Up
NOTICE
set
ART 02492
30 31
32
280
278