Thetford 2118 Series Installation Manual - Manuel (Page 14)

Installation Manual 14
- Pull using a wire-form tool hooked into mounting holes [121] of the
refrigerator frame (See Art01808).
Make sure the foam combustion seal is not broken, is
completely around the refrigerator mounting fl anges,
and is between the mounting fl anges and the wall of
the enclosure If the seal is not complete, exhaust
fumes can be present in the living area of the vehicle.
The breathing of exhaust fumes can cause dizziness,
nausea, or in extreme cases, death.
3. Put the refrigerator in position:
Be careful when you put the refrigerator into position. It is not
necessary to remove the protective packaging from the doors
of metal door models to install or operate the refrigerator.
- Make sure that the fl ue cap is not pushed down against the top of the fl ue
tube.
- Push the refrigerator completely into the enclosure.
4. Install the mounting screws and trim (See Art01814):
- Put the four screws [41] through both the upper and the lower mounting
fl anges on the front of the refrigerator and into the enclosure wall.
- Push the trim pieces [40] onto the front of the refrigerator.
- Put screws through the mounting fl ange on the rear of the refrigerator and
into the fl oor.
5. On metal door models only, you may wish to remove the protective packaging
from the doors.
Be careful to not scratch or dent the metal doors. Do not use
any abrasive cleaners, chemicals, or scouring pads because
they can damage the fi ninish of the doors.
Connect the Electrical Components
AC Operation 120 volts (132 volts max. - 108 volts min.)
12 volts (15.4 volts max. - 10.5 volts min.)
DC Operation 12 volts (15.4 volts max. - 10.5 volts min.)
This refrigerator operates on these electrical sources. Operation out of these limits may damage the refrigerator’s electrical circuit
parts and will void the warranty.
WARNING
!
NOTICE
NOTICE
209
41
Art01850
40
41
Art01814
40
41